written by GS1949 on 04/11/2012
I was given one of these older machines by a friend. Certainly cheaper to run than a kettle.
I have overcome the 'lack of' softener cartridges, we use a Water Jug with it's own cartridge and I removed the cartridge from the Tefal. It seems to work very well.
As some say, it's a bit splashy with dispensing water, but apart from that very good.
I must find the instructions, as I didn't know about the descale function.
As rated by our community of reviewers
Paule's Response to GS1949's Review
Written on: 03/02/2013
If the blue light comes, it needs de-scaling....
To reset, simply hold both top buttons down until the blue light goes out!
Simples!
Gs1949's reply to Paule's Comment
Written on: 04/02/2013
Thanks.
I haven't seen any blue light yet !
When I do, I hope I will have remembered your tip.
Is there any way to stop the water splashing about when filling the cup?
I've tried cleaning the spout filter thing but sometimes it splashes out the cup.
Thank you.
Paule's reply to Gs1949's Comment
Written on: 05/02/2013
Here is the correct way to descale:
Descaling your appliance
In order to optimise the lifetime of your appliance, we recommend that you descale it at least every 2 months.
Descaling should be carried out more frequently if you live in a very hard water area.
Certain models also have an indicator light K, which indicates when descaling is necessary. When this
indicator K is on during use, it is time to descale the appliance.
To descale:
1 Remove the Claris filter cartridge fig 6.
2 Place a container of at least 1.5 litres under the nozzle.
3 Empty the tank A, if it is still full of water, then reposition it on its base fig 2.
4 Pour 1 litre of commercially available white vinegar at 8° into the tank.
5 Press the hot water button H and the ambient water button G simultaneously for at least 5 seconds fig 7.
You have the possibility of launching a descaling cycle even if the indicator light K is not on. To do this, press
the hot water button H and the ambient water button G simultaneously for at least 10 seconds
6 The descaling cycle thus runs automatically for approximately 10 minutes.
The indicator turns off at the end of the cycle.
7 When the cycle has come to an end, empty the container and refill the water tank to a maximum.
Relaunch a new operation for rinsing the appliance by holding down one of the buttons fig 3 and fig 10.
8 Once this last cycle has finished, reposition the Claris cartridge; your appliance is ready for use once more
As regards splashing:
Its the nature of these machines, just try and raise the cup on block of wood, when ur filling it to prevent splashing.................