Replacement tines

Click here if this is your business
★★☆☆☆
2.3 / 5
19% of users recommend this
Click here if this is your business
  • Value For Money

phi.ayrshire's review of Mac Allister MRS1400 Scarifier

★★★★★

“Replacement tines”

Written on: 26/04/2020 by phi.ayrshire (1 review written)

Value for money and has done a power of work over last 3 years. Eventually the tines broke from use but scarifier attachment is still good. Spare tines are hard to find but eventually identified a supplier. They are type 6 tynes, 50mm long with hole diameter 12mm to fit a 10mm shaft. I could only find one supplier, Solent tools. They were easy to replace. Hope this helps.

  • Value For Money

If you are commenting on behalf of the company that has been reviewed, please consider upgrading to Official Business Response for higher impact replies.

Kabous's Response to phi.ayrshire's Review

Written on: 07/08/2020

Hi, wonder if you will share how to replace tines. That is if I can still find some as Solent out if stock.
I've taken out the axle to inspect and can knkh find joke on side of each plastic cam. Not looked further.
Your help will he greatly appreciated.

Reply to this comment
If you are commenting on behalf of the company that has been reviewed, please consider upgrading to Official Business Response for higher impact replies.

Phi.ayrshire's reply to Kabous's Comment

Written on: 10/08/2020

Photograph tines so you put the new ones back facing same direction. On the opposite side from the roller you will see a pin that goes through the bar jammed up against then last tine. Knock that pin out with a small hammer and something similar to a small screwdriver or a nail or similar. It is only held by friction. All the tines will then slip off the bar. Replacement is the reverse procedure.

Reply to this comment
If you are commenting on behalf of the company that has been reviewed, please consider upgrading to Official Business Response for higher impact replies.
Report this review
Was this review helpful? 3 0