Have a picture of CZ T200?, please send it to us.
Picture courtesy of Alexa.
| Accuracy | 9.5/10 |
|---|---|
| Handling | 8.5/10 |
| Value for Money | 9.5/10 |
| Reviewer Rating | 9.3/10 |
| Overall Rating | 7.8/10 |
Full review by
Guest.
on 25th Aug 2008
![]()
![]()
User Rating : 9
Respect :
0
Good Points: Accuracy is impressive and is extremely good value for money.
Bad Points: Cant think of anything of the top of my head
General comments: Awesome little rifle, for this price range quality is unsurpassed. Shot about 10 000 shots with my T200 over an 18month period and never had any problems
Guest.'s review and ratings | 45 words
Review by
bobjbrown![]()
on 15th Mar 2008
![]()
![]()
User Rating : 9
Respect :
0
I went to this rifle because it is relatively light, accurate and tough.
Ideal for HFT.
Don't be put off by the short overall length, the barrel is set well back in the rifle making it as accurate as longer rifles that are loaded further forward.
Although build quality is good; as new the trigger and bolt actions seem a little "gritty". After the first 1000 pellets they are freeing up and seem to have bedded in nicely.
I normally fill to 200 bar and run down to half that with little deprecia ...
bobjbrown's full review | 292 words | 1 comment added.
Review by
pyro69
on 2nd Aug 2005
![]()
User Rating : 10
Respect :
+2
A fantastic 1st air rifle for new comers due to the good points stated above. The CZ T200 is totally adaptable and can be used for both hunting and target shooting but it's lack of a safety device is a major down side especailly when loading as the cocking lever is very close to the trigger and the gun could very easily be set off. Overall I personally think this gun to be excellent and great value for money
pyro69's full review | 86 words | 1 comment added.
Review by
Harry van Niekerk![]()
on 8th Jul 2005
![]()
![]()
User Rating : 9
Respect :
+1
I refilled the cylinder of my CZ T200 which was at 120 bar. Just over 150 bar the air started blowing out the small hole in front. When the pressure was back at 150 bar it stayed there without blowing out. I always personally fil my cylinder and have never filled it over 200 bar. Has anyone experienced this and if so what are the implications.
Harry van Niekerk's full review | 64 words | 1 comment added.

Would you like to see a review that's not being listed?