Just recently purchased a cbr 125 in march 2013 brand new,when driving it home from the showroom it was smooth as silk and by far the best 125 i have ever ridden. However, after 2days of having it,i started it up one morning (sweet as a nut)and after travelling about 150yds came to a junction and it cut out on me. It took a few touches of the starter button to get it going again and took a while to get up to 3000 rpm? Even after this the bike seemed rather slugish and it seemed as if the clutch was dragging out, until after about 3 or 4 mile.I put it down to it being cold but it happend again that evening. I immediately contacted the dealer i bought it from and they collected the bike off me to keep overnight to see if the problem happened again the following morning from cold. I phoned the next day to see if the problem happened again and it hadnt. I asked were there any problems found and the reply i got was nothing was found except the clutch had been adjusted and it was on its limit?? Told them i hadnt adjusted anything and it was exactly the same as when i had it from the showroom. Anyway, i had the bike back and exactly the same thing happened, started,then cut out on me, then took several attempts to start it again to the point where you think your gonna flood the engine. I eventually got it started(again struggling to get it to 3000rpm)when after about 2 or 3mile rideing it it would go from 2nd gear into neutral and this happened on several occassions.I dont know if ive been sold the runt of the litter or what but for a brand new machine somethings not quite right.Taking it back to dealer tmrw for a different machine and if thats the same then im switching to yamaha!!