written by Almam404 on 05/09/2016
Agree with all comments fairly poor to begin with, but a bit of adjustment got it to chip / shred very well. A good engineer could sort this minor problem very easily , not a big enough gap between cutting blade and mount, (only my opinion)i am not an engineer , hope this is of some use to those of you that did keep hold of your chipper. cheers my green fingered gardeners
Once we've checked over your question we will put it live on the site and our strong community of experts will hopefully give you some great answers that you find useful.
We will email you when the question is on the site
Once we've checked over your answer we will put it live on the site so others can gain from your experience. We rely on members like you to sustain our vibrant community so thanks again, we couldn't do it without you.
We will email your when your answer is on the site
Once we've checked over your answer we will put it live on the site so others can gain from your experience. We rely on members like you to sustain our vibrant community so thanks again, we couldn't do it without you.
We will email your when your answer is on the site
As rated by our community of reviewers