daisy powerline 1200 review

Have a picture of Daisy Powerline 1200?, please send it to us.
Picture courtesy of Richard Schmand.

Average Ratings

Value for Money	8.2/10
Reviewer Rating	8.4/10
Overall Rating	7.7/10

86% Recommended12 out of 14 Reviews

Quick Links

Write your review

Review of Daisy Powerline 1200

• Previous
• Review 13 of 14
• Next

By radeeoh on 22nd May 2005

radeeoh's Ratings

Value for money	10/10
Overall value	10/10
radeeoh's recommendation

Good Points

Accurate. feels good in your hand and the action is very smooth.

Bad Points

None

General Comments

I have had my Daisy Powerline 1200 Air Pistol for over 20 years and a gun of this quality would cost well over a hundred dollars at today's prices. I love the accuracy as I live in an area of Rattle snakes and I have never had one get away yet when I'm carrying this Daisy. My only problem at the moment is the seal where the Co2 inserts into the chamber. I can not install the Co2 cartridge as it will not completely seal and I loose all the propellant. Is this an easy fix or do you have to send the gun to Daisy for repairs?

4 Comments on Review by radeeoh for Daisy Powerline 1200

1. hotsky on 23rd May 2005

   Not sure how easy it is to fix (don‘t know you’re model), but it sounds like you need new seals (all CO2 guns eventually need them replaced). What you can try is; drop a couple of drops of PellgunOil on the seals (but make sure it actually goes inside the valves). It may help but only for some time.

2. deadblow on 26th Dec 2005

   I had the same problem with the co2 seal. I had to remove the old seal. I found some light rust under the seal. I then used a blue and rust remover to clean the rust off of the co2 seat. Next I made a crude seal with a small thin piece of rubber and reinstalled it. It works fine now with no co2 loss. Hope this helps you. My gun was out of commission for 10+ years. I finally made up my mind to fix it. Oh the years wasted....anyway, happy shooting!

3. radeeoh on 26th Dec 2005

   Thanks much for the tip. I was able to contact Jim Coplen who does repairs and also has a nice supply of parts for the PowerLine 1200. I called him and received the seals and an entire chamber. These are new old stock (NOS) parts. My gun is over 20 years old and my problem was I would leave a CO2 Cartridge in the gun so it was always ready to go. Lots of Rattlers where I live. That's what ruined my seals. Now I have a cartridge in the gun, but do not puncture the seal until I need it. I then make sure I don't leave it in the gun under pressure when I'm through using it.
   Here is Jim's Address:
   Jim Coplen
   P.O. Box 7297
   Rochester, MN 55903
   Telephone: 507-281-2314
   Thanks again for the tip as I may need it some day.

4. jjjjaz on 18th Jun 2007

   I also have an older 1200 pistol. Due to drying seals it is also losing all the co2. These are internal seals, not the small gaskets that Daisy can give you. Daisy no longer fixes these. The parts were sold to jim copeland 507-281-2314. He would charge about $40. or so.

• Daisy Power Line
• CO2 BB Guns

Would you like to see a review that's not being listed?

Web Results

Powerline 1200 Daisy
Powerline 1200 Daisy - Ppl Motor Home - Pravacol Have Side Effects, Ppc 6700 Audiovox Review...
members.lycos.co.uk

Powerline 1200 Daisy
Powerline 1200 Daisy - Pre-unit British Twins Road Tests - Pre Owned Bmw Cars For Sale, Precious - Dj Dan?s 6am Dub Mp3, Prayer Braclets Swavorski Crystals.
members.lycos.co.uk

Daisy Powerline 1200 Review - Air Pistols. Review of 157526
Daisy Powerline 1200 in Air Pistols / Shooting reviews at Review Centre...
www.reviewcentre.com

Daisy Powerline 1200 Review - Air Pistols. Review of 119845
Daisy Powerline 1200 in Air Pistols / Shooting reviews at Review Centre...
www.reviewcentre.com